BAR LOADER/MAGAZINE TYPE,HYDRAULIC & MECHANICAL
FMB Turbo 3-26, 1/16" - 1" x 12, for Fixed and Sliding Headstock, NEW
General Specifications as per Brochure:
Bar Diameter Capacity:
w/out prep: .118" - 1.02" (3mm - 26mm)
with prep: .118" - 1.102" (3mm - 28mm)
Max. bar length: 3800 mm (12' 5")
Min. bar length: 1000 mm (39.4")
Max. remnant length: 420 mm (16.54"
Magazine rack capacity: 11"
Bar loading cycle time: 26 seconds for 12' bar
Material straightness specification: .007" TIR/ft. of material
(V blocks, 3 points equidistant)
Feed force (pusher torque): max 4560 N, adjustable
Forward feed rate: 1400 IPM, adjustable
Return feed rate: 2360 IPM, adjustable
Power consumption: 1.5 kw
Operating voltage: 230V/60hz 3-phase
Control voltage: 24V DC
Oil capacity: 80 liters (22 gallons)
Oil viscosity: ISO 150 cST
Compressed air supply: 6 bar (90 psi)
Compressed air consumption: approx. 10 liters per loading cycle
Weight (approx.): 3,025 lbs
(1) Guide channel set of your choice (channel sections, pusher & revolving
(1) Universal telescopic nose w/ID liner
(1) OD bar stock pusher collet
(1) Custom lathe cable & interface plug
FMB Turbo 3-26 12' 2 Guide Channel Set Complete Package: $42,900.00
Includes (2) Channel Sets, (2) Pushers, (2) Nose Liners & (2) Pusher Collets
Optional Accessories - Prices Subject to Change:
Additional Guide Channel Sets: $3,350.00 ea.
(includes pusher, revolving tip, nose liner & spindle liner)
Additional Spindle Liners: $420.00 ea.
(needed when using a guide channel set below the lathes bar capacity)
Additional Bar Stock Collets: $145.00 ea.
(1 needed for each size bar stock to be run)
Polyurethane Bushing Blocks: $140.00 ea.
(1) set includes upper & lower pieces and is used in place of rollers
in standard steady rest when machining hex, square or profiled stock
Air Knife: $1,500.00
(recommended to minimize bar feeder oil loss when running shafts)
Long Pusher Kit: $2,400.00 ea.
(required for some lathes)
Extra Long Pusher Kit: $3,900.00
Axial Device with Safety Switches: $2,900.00
Dual Channel Safety Switch: $ 500.00
Moveable Roller Steady Kit: $2,900.00
Bundle Loader Option for 5000 # Material Contact Edge
Bar Feeder installation does not include lathe-side software or hardware
interface. This interface must be supplied and installed by the lathe
OEM or dealer prior to bar feeder installation.
The anchoring of the FMB bar feeder to the floor is a requirement and will be
performed by the service technician.
Automatics & Machinery Co Inc
150 Martin St
Longmont CO 80501-5939
Email (Request Quote):