BAR LOADER/MAGAZINE TYPE,HYDRAULIC & MECHANICAL
2 1/2" Dia, ATS, ML565, 2011, 5', for Fixed Headstock, Nearly New!
General Specifications as per OEM brochure. Buyer should verify details.
Both long and short legs.
Originally configured on Eurotech
Replacement cost about $15K
TECHNICAL SPECIFICATION from Manual
Scope of application Bar dimension
Bar round cross section: 6 to 67 mm
Bar hexagonal cross section: 8 to 58 mm
Bar square cross section: 8 to 47 mm
Maximum weight of the loaded bar: 60 kg
Maximum length of the bar: 1525 mm
Magazine capacity depending on the bar diameter
8 bars: 80 mm
The # of bars limited by the table cap 6 mm
Max Weight of all bars on Table: 250 kg
Design stroke: 1665 mm
Working stroke: 1660 mm
Max dist of the clamping device face 1655 mm
from the pusher point in back position
Technology of bar handling
The bar is cantered in the lathe spindle by spindle inserts, and shifted
by the pusher to a stopper in the tool head.
Bar loading cycle: approx. 30 s
Setting time at change of bar diameter: Max. 1 minute at change diameter
+ time of lathe spindle insert
Power supply: 200/230/400 VAC, 50/60 Hz, 320 VA
Power circuits: 200 VAC, 24 VDC
Logic circuits: 24 VDC
Weight: approx. 375 kg
Transport dimensions: L 2230 x W 1150 x H 1220 mm
The barfeeder ML-565/580 T/S is a powerful machine with a long service life
and minimal maintenance required. Its operation and functions are simple which
facilitates the work even to less skilled workers.
The barfeeder is controlled by means of the control panel in the right part of
the machine. There is an E-Stop pushbutton for emergency stop on the control
panel. In the left part of the barfeeder frame there is a Q1 switch.
Bars are loaded in the magazine. Loading of bars into the lathe is ensured by
a loading channel with a flag and pusher.
On the rear side of the frame there are connectors X1, X2 for barfeeder
interconnection with the lathe.
Automatics & Machinery Co Inc
150 Martin St
Longmont CO 80501-5939
Email (Request Quote):